Skip to content

1:35 to 75mm Miniature Scale for 3D Printing

Convert 3D printed tabletop miniatures from 1:35 to 75mm. This STL scale calculator is designed for Warhammer, D&D, and tabletop gaming miniatures.

Slicer Setting

150.0%

Uniform scale (XYZ locked)

Open in stlscale

The math

(75.0mm / 50.0mm) × 100 = 150.0%

Based on 175cm human baseline, eye-level measurement (160cm).

Scale baselines

  • Source eye level 45.7mm Eye
  • Target eye level 75.0mm Eye
  • Scale factor 150.0%

When you need this

You need this when bringing older or smaller 1:35 models into a modern 75mm collection. This is a big upscale. Models will look like different species next to each other unless you apply the conversion to the entire unit or army.

Source: 1:35

1:35 is the military model kit standard. A true ratio scale, not a 'gaming scale.' A 1:35 human is approximately 50mm tall to the top of the head and 45.7mm to the eyes. Vehicles and armor dominate this scale. Common systems: Tamiya, Trumpeter, MiniArt.

Note: 1:35 figures from different manufacturers can vary by plus or minus 2mm due to nationality and era differences in uniform and equipment.

Target: 75mm

75mm is used by Display busts, Figure painting competitions, Scale 75 display line. Not a tabletop wargaming scale. A 75mm figure is roughly 1:24 scale and designed for contest judging and display cabinets. Eyes and skin texture become the primary focus.

Note: 75mm sculpts often have separate heads or arms for easier painting access. Check assembly instructions before scaling a monolithic STL.

Print notes

Set your slicer to 150.0%. 75mm on FDM needs a 0.2mm nozzle and very slow print speeds for acceptable surface quality.

If STLACCESS saved you time, consider supporting the Engine.

Every contribution helps keep STLACCESS free and independent.

☕ Support STLACCESS